Open Discussion Group

Frame Separating linkage on Bridgestone Moulton

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 1, 2015 at 9:14 pm #4912
    Will Temple
    Member

    I’ve found out what it is :

    M8 Left Handed Thread with two locking nuts and an Allen Screw Head. The inner thread is a steel insert held in with a locating grub screw.

    Just fabricated one up and the frame is now held together nice and firm. Not sure how tight I should tighten it still – Does it matter ?

    Will

    October 4, 2015 at 7:51 pm #4913
    Keith Henderson
    Participant

    You have the Allen key from the little caddy on the bike frame. I would tighten it quite firmly but not going “over the top” if you see what I mean.

    Keith

    October 5, 2015 at 6:41 pm #4914
    Will Temple
    Member

    Thanks very much Keith,

    That’s what I assumed in the end, but it’s nice to have it confirmed.

    Will

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.