Open Discussion Group

SA 3speed hub newbie question

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #2413
    John Theroux
    Participant

    Just purchased a 65 Standard, my first Moulton. The 3 speed hub is unlike any I’ve ever seen. No way to determine if adjustment has been properly completed as you only see a threaded rod in the sight hole. Any advice thanks.

    #3724

    Hello John,
    could you upload a picture to a Photosharing site like flickr?
    Probably this would help us to understand the problem.
    Also, are the washers placed correctle on the axle? At one of our bikes I had to change to a normal axle nut because I was only an+ble to see the thread of the axle through the sight hole after adding a trailer hitch.

    Hope this helps,
    Thorsten

    #3725
    Pandora
    Participant

    So many reasons,
    AW hubs made in long and short axle length, the indicator rod is also a matching long or short, It may be your hub has a replacement indicator rod which is not the correct part for your hub

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.