Open Discussion Group

TSR – How to setup the fork?

Tagged: ,

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 4, 2012 at 2:34 pm #2364
    Per Gunnare
    Participant

    I got a new TSR frame set and have some questions on how to setup the fork:

    1. There are quite a few parts on the head set
    a) Which order are the bearings, washers, stoppers etc? Is there some drawing somewhere?
    b) How should the bearings be oriented?

    2. Suspension:
    a) How to lubricate the telescopic part?
    b) Does it have to be dissambled first?
    c) How to lubricate the lower part? Just some teflon based light oil?

    Sorry for a lot of basic questions.

    Per

    September 4, 2012 at 3:39 pm #3476
    Ian
    Participant

    At the top of this page – ‘Resources’ tab. Pick ‘Technical Topics’ then choose ‘APB Front Suspension’ would be a good start!

    September 5, 2012 at 11:54 pm #3477
    Per Gunnare
    Participant

    Thanks, I’ll have a look at that to start with.

    Per

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.